Technical Values
| Location | Description | Type | Basic Value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Sliding-Roof Panel To Roof, Front (D1) | Only Lowered | Gap Dimension | 0 mm | -0.5 mm | |
|
Adjusting Height At The Front |
|||||
| Sliding-Roof Panel To Roof, Rear (D2) | Only Raised | Gap Dimension | 0 mm | +0.5 mm | |
|
Adjusting Height At The Rear |
|||||
| Front Fastening Screw | Item 2A | Tightening Torque | 8 Nm (6 ft. lbs.) | ||
|
Adjusting Height At The Front |
|||||
| Fastening Screw On Panel, Centre/Rear | Item 2B, 2C | Tightening Torque | 5 Nm (3.5 ft. lbs.) | ||
|
Adjusting Height At The Rear |
|||||
| Gap Between Sliding Roof Panel And Roof | Gap Dimension | 0.5 mm | -1 mm | ||
|
Checking Panel Joints |
|||||