Adjusting Sliding-Roof Panel
- Close the panel and adjust gaps at the front -1-
and rear -2-
.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Adjust the height -D1-
at the front sliding-roof panel by moving the panel.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Tighten fastening screw -2A-
.
- Adjust the height -D2-
at the rear sliding-roof panel by moving the panel.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
- Tighten fastening screws -2B, 2C-
.
- Check gap dimensions and re-tighten fastening screws to the specified torque.
- Gap dimension - height at front (D1) Gap dimension 0 mm -0.5 mm
.
- Gap dimension - height at rear (D2) Gap dimension 0 mm +0.5 mm
.
- Front fastening screw Tightening torque 8 Nm (6 ft. lbs.)
.
- Rear fastening screw Tightening torque 5 Nm (3.5 ft. lbs.)
.
- Gap between sliding-roof panel and roof Gap dimension 0.5 mm -1 mm
.