Installing Mounting Unit

Information 

Fit square nut that is further away from the bore with respect to the edge up into the bracket.

1. Push drive shaft -1-  of the mounting unit -2-  into the guide tube.
   Fig 1: Pushing In Mounting Unit

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Install mounting unit -1-  in the assembly frame -arrow-  .
   Fig 2: Installing Mounting Unit

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Fit outer -1-  and inner -2 -  fastening screws at the front and tighten hand-tight.
   Fig 3: Installing Front Mounting Unit

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Fit rear fastening screws -1-  and tighten hand-tight.
   1. 4.1. Position retaining bracket -3-  and tighten fastening screw -2-  hand-tight.
      Fig 4: Identifying Rear Mounting Unit

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
5. Fit fastening screws -1-  used to secure the mounting unit to the assembly frame at the sides and tighten hand-tight.
   Fig 5: Securing Mounting Unit Frame Assembly

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
6. Insert wiring harness -1-  into the guide rail -2-  .
   Fig 6: Identifying Wiring Harness For Electric Drive

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
7. Push mounting unit -1-  at the left and right onto the rear lock with your hand.
   Fig 7: Pushing Mounting Unit

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
8. Position metal clip -1-  and engage it in the mounting.
   Fig 8: Identifying Metal Clip

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
9. Install safety clip -1-  .
   Fig 9: Identifying Safety Clip

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
10. Tighten fastening screws to the specified torque.
11. Fastening screw for outer front mounting unit. Tightening torque 3 Nm (2 ft. lbs.) 
12. Fastening screw for inner front mounting unit. Tightening torque 3 Nm (2 ft. lbs.) 
13. Fastening screw for rear mounting unit. Tightening torque 3 Nm (2 ft. lbs.) 
14. Fastening screw securing retaining bracket to guide tube. Tightening torque 3 Nm (2 ft. lbs.) 
15. Fastening screw securing mounting unit to assembly frame. Tightening torque 3 Nm (2 ft. lbs.)