Installing Front Seat
WARNING:
Incorrect handling of safety bolts
- Danger of injury
- Loss of torque
→ Always use new fastening screws and nuts following removal.
→ Observe specified tightening torques.
→ Carry out a visual inspection of all re-used parts.
Information
- Replace fastening screws (micro-self-locking).
Information
The routing of the wire harness for the control unit must be checked before installing the seat.
The wire harness must not be routed over the cover, but should be laid alongside the cover.
Information
Before installing and securing the front seat, make sure the electric lines are not pinched or damaged.
- Installation is performed in reverse order to removal.
- Fastening screw securing front seat to body Tightening torque 50 Nm (37 ftlb.)