Installing Trim Panel For Rear Lid

Information 

Check that the fixing clips are not bent or broken.

Replace missing or damaged fixing clips with new ones.

Make sure that all fastening clips have engaged correctly.

Check that they are fitted correctly.

Information 

• Bonding surface must be clean and free of grease. Clean with cleaning solution if necessary. 

1. Installation is performed in reverse order to removal.
2. Tighten fastening screws to the specified torque. Tightening torque 2.2 Nm (1.5 ftlb.) +/-0.2 Nm (+/- 0.1 ftlb.) 
3. Clean bonding surfaces.
4. Stick on section Item 7  using double-sided adhesive tape.