Sliding Roof

Location	Description	Type	Basic value	Tolerance 1
Fastening screw for air deflector bracket, left/right		Tightening torque	2 Nm (1.5 ftlb.)
Fastening screw for air deflector cable	Item 1	Tightening torque	0.5 Nm (0.5 ftlb.)	0.7 Nm (0.5 ftlb.)
Securing air deflector cable
Fastening screw on lid at front		Tightening torque	8 Nm
Fastening screw on lid at centre/rear		Tightening torque	5 Nm
Sliding-roof panel to roof, front (D1)	Only lowered	Gap dimension	0 mm	-0.5 mm
Adjusting height at the front
Sliding-roof panel to roof, rear (D2)	Only raised	Gap dimension	0 mm	+0.5 mm
Adjusting height at the rear
Front fastening screw	Item 2A	Tightening torque	8 Nm (6 ftlb.)
Adjusting height at the front
Fastening screw on panel, centre/rear	Item 2B, 2C	Tightening torque	5 Nm (3.5 ftlb.)
Adjusting height at the rear
Gap between sliding roof panel and roof		Gap dimension	0.5 mm	-1 mm
Checking panel joints
Fastening screw securing sunroof motor		Tightening torque	3 Nm (2 ftlb.)
Removing motor
Fastening screw securing sun blind motor		Tightening torque	3 Nm (2 ftlb.)
Removing motor
Fastening screw for outer front mounting unit	Item 1	Tightening torque	3 Nm (2 ftlb.)
Front mounting unit
Fastening screw for inner front mounting unit	Item 2	Tightening torque	3 Nm (2 ftlb.)
Front mounting unit
Fastening screw for rear mounting unit	Item 1	Tightening torque	3 Nm (2 ftlb.)
Rear mounting unit
Fastening screw securing retaining bracket to guide tube	Item 2	Tightening torque	3 Nm (2 ftlb.)
Rear mounting unit
Fastening screw securing mounting unit to assembly frame	Item 1	Tightening torque	3 Nm (2 ftlb.)
Assembly frame mounting
Fastening screw for transverse bow	Item 1	Tightening torque	2.5 Nm (2 ftlb.)
Transverse bow mounting