Adjusting Rear Spoiler

→ Move the additional wing to the lowest position for use on public roads.

→ The spoiler wing position may only be changed for race track driving.

Fig 1: Identifying Rear Spoiler Installation Position (Upper Part)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

1. Adjustment position 1  (road use)
   Fig 2: Adjusting Rear Spoiler To Position 1 (Road Use)

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   1. 1.1. Loosen fastening screw -1-  .
   2. 1.2. Unscrew fastening screw -2-  .
   3. 1.3. Swivel rear spoiler (upper part) to position 1  .

      Information 

      • After making adjustments, the fastening screws must always be secured with Loctite 241 screw-locking lacquer. 
   4. 1.4. Screw in and tighten fastening screws to Tightening torque 9.7 Nm (7.5 ftlb.)  .
2. Adjustment position 2  (race track use)
   Fig 3: Adjusting Rear Spoiler To Position 2 (Race Track Use)

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   1. 2.1. Loosen fastening screw -1-  .
   2. 2.2. Unscrew fastening screw -2-  .
   3. 2.3. Swivel rear spoiler (upper part) to position 2  .

      Information 

      • After making adjustments, the fastening screws must always be secured with Loctite 241 screw-locking lacquer  .
   4. 2.4. Screw in and tighten fastening screws to Tightening torque 9.7 Nm (7.5 ftlb.)  .
3. Adjustment position 3  (race track use)
   Fig 4: Adjusting Rear Spoiler To Position 3 (Race Track Use)

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   1. 3.1. Loosen fastening screw -1-  .
   2. 3.2. Unscrew fastening screw -2-  .
   3. 3.3. Swivel rear spoiler (upper part) to position 3  .

      Information 

      • After making adjustments, the fastening screws must always be secured with Loctite 241 screw-locking lacquer  .
   4. 3.4. Screw in and tighten fastening screws to Tightening torque 9.7 Nm (7.5 ftlb.)  .