LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> 66 - Exterior Equipment -- 911 CARRERA (991) >> WM 663519 Removing And Installing Trim Panel For TARGA Bar (TARGA 4, TARGA 4S, TARGA 4 GTS) >> Installing Trim Panel For Targa Bar

Installing Trim Panel For Targa Bar

  1. The side trim panel is installed without the assembly clip. 
  2. Installation is performed in reverse order to removal.
  3. Position side trim panel at the previously marked areas and tighten fastening screw to.
  4. Position side trim panel at the previously marked area and tighten fastening nuts to.
  5. Position trim panel flaps at the previously marked area and tighten fastening screws to.
  6. Position center trim panel at the previously marked area and tighten fastening screws to.
  7. Adjust gap dimensions of the trim panel if necessary. → 663515 ADJUSTING TRIM PANEL FOR TARGA BAR 
scientia non olet · About LEMON Manuals