Installing Door Entry Guard

Installation is performed in reverse order. Pay particular attention to the following: 

• Check that the door entry guard is fitted exactly. Check gap and joint dimensions.

1. Tighten fastening screw securing rear wheel housing liner to the body to the specified torque. Tightening torque 2 Nm (1.5 ftlb.) +10 % -15 % 
2. Tighten fastening screw for front wheel housing liner to the specified torque. Tightening torque 3.2 Nm (2 ftlb.) +10 % -15 % 
3. Tighten rear fastening screw for underside to the specified torque. Tightening torque 3.2 Nm (2 ftlb.) +10 % -15 %