Installing Front Spoiler (At The Left And Right)

Information 

• Carefully clean any dirt, grease, wax and other impurities off the installation area of the body using isopropanol. 
• Always use a clean cloth. 
• The room and object temperature must be at least → Nominal value: +15°C. 
• Humidity should be → Nominal value: 50 %+/-10 %. 
• Do not touch the bonding surface again after removing the protective paper. 
• Wear clean gloves during the bonding process in order to guarantee adequate adhesion. 
• The parts must have been bonded for at least → Nominal value: 72 h before washing the vehicle in a car wash. 

1. Installation is performed in reverse order to removal.
2. Tighten fastening screws on the front apron to Tightening torque 3.2 Nm (2 ftlb.) +10 % -15 %  .