Installing Rear Apron
NOTE:
Heat protection panels not fitted correctly
- Risk of damage to adjacent parts
→ Make sure the heat protection panels overlap correctly.
→ Replace damaged or deformed heat protection panels.
→ Check heat protection panels for deformation, secure fixing of the aluminum braided cord, cracks and missing or damaged fixing tabs.
→ At least 80% of the total sealing area must be sealed without gaps.
Information
Two people are needed to remove and install the rear apron!
- Installation is performed in reverse order to removal.
Fastening screw at top of rear apron. Tightening torque 3.2 Nm (2 ft. lbs.) +/-0.6 Nm (+/-0.5 ft. lbs.)
Fastening screw at bottom of rear apron. Tightening torque 3.2 Nm (2 ft. lbs.) +/-0.6 Nm (+/-0.5 ft. lbs.)
Fastening screw (item 3) Tightening torque 7 Nm (5 ft. lbs.) +/-0.7 Nm (+/-0.5 ft. lbs.)