Installing Rear Bumper
NOTE:
Heat protection panels not fitted correctly
- Risk of damage to adjacent parts
→ Make sure the heat protection panels overlap correctly.
→ Replace damaged or deformed heat protection panels.
→ Check heat protection panels for deformation, secure fixing of the aluminum braided cord, cracks and missing or damaged fixing tabs.
→ At least 80% of the total sealing area must be sealed without gaps.
Installation is performed in reverse order to removal.
- Fastening screws for bumper. Tightening torque 23 Nm (17 ft. lbs.) +/-2 Nm (+/-1.5 ft. lbs.)
- Fastening screws for heat protection. Tightening torque 3 Nm (2 ft. lbs.)