LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> 50 - Body Front- 911 CARRERA (991) >> WM, 507955 Replacing Front Side Member (Section) >> Preparing Connection Areas Of Body For Installing Side Member >> Replacing Rivet Nut

Replacing Rivet Nut

  1. Unscrew threaded bolt.
  2. Drill out rivet nut. > Diameter 9 mm 
    G14222726Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Removing rivet nut

  3. Remove rivet nut.
  4. Fit sub-part and secure it to the body.

    Position sub-part using the straightening system.

    1. 4.1  Drill bores for rivet screw through the existing hole. > Diameter 9 mm 
  5. Remove sub-part.
  6. De-burr bores on both sides.
  7. Following final installation of the side member, fit a > RIVET SCREW N107 608 01  .
scientia non olet · About LEMON Manuals