Preparing Connection Areas Of Body For Installing Spring Strut Mount
- Fit in spring strut mount and secure it to the body. Check gap dimensions.
> 5X00IN DIAGRAM - BODY GAP DIMENSIONS
Position spring strut mount using the straightening system.
- 1.1 Drill bores for the rivets through the existing holes. > Diameter 6.5 mm
- 1.2
Offset bore -1-
so that it is moved outward slightly -arrow A-
.
Drilling holes
- 1.3
Drill two holes -arrows B-
on the supports between the spring strut mount and longitudinal member.
Offset the bores for the drilled-out rivets -1 and 2- so that they are moved up slightly.
Offsetting bores
- Remove spring strut mount.
- Prepare connection areas on the body for bonding.