Preparing Longitudinal Member For Wheel Housing

Check gap dimensions. → WM 5X00IN GAP DIMENSIONS (EXCEPT CARRERA "EDITION", CARRERA CABRIOLET "EDITION", CARRERA 4 "EDITION", TARGA 4, TARGA 4S, TARGA 4 GTS, CARRERA 4 CABRIOLET "EDITION")

1. 1.1. Drill holes for rivets through the existing holes using a drill bit with a diameter of → Diameter: 6.6 mm  .
   Fig 1: Identifying Outer Upper Longitudinal Member Adhesive Applying Areas

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Check gap dimensions. → WM 5X00IN GAP DIMENSIONS (EXCEPT CARRERA "EDITION", CARRERA CABRIOLET "EDITION", CARRERA 4 "EDITION", TARGA 4, TARGA 4S, TARGA 4 GTS, CARRERA 4 CABRIOLET "EDITION")

1. 2.1. Drill holes for rivets through the existing holes using a drill bit with a diameter of → Diameter: 6.6 mm  .
   Fig 2: Identifying Upper Longitudinal Member Adhesive Applying Areas

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.