Installing Front Wheel Housing Liner - Rear Section

Installation is performed in reverse order. Pay particular attention to the following: 

1. Tighten fastening screws securing wheel housing liner to the body to the specified tightening torque. Tightening torque 3 Nm (2 ftlb.) 
2. Tighten fastening nuts securing wheel housing liner to the body to the specified tightening torque. Tightening torque 3 Nm (2 ftlb.) 
3. Tighten fastening screws securing air vane to the body to the specified tightening torque. Tightening torque 3 Nm (2 ftlb.)