Securing Main Wire Harness In Passenger Compartment At The Left
- Risk of damage to lines
→ The main wire harness contains all airbag lines, antenna lines and optical waveguides.
→ The main wire harness must not be separated and is always replaced as a complete wire harness when carrying out extensive repairs.
→ If individual lines are damaged, shut off these lines and install new lines. Lay the new lines along the main wire harness and secure them to the main wire harness.
Information
Always comply with the regulations for handling ESD-sensitive components!
- Assembly work may only be carried out if the mechanic is wearing the working clothes and shoes approved by Porsche.
- The new part must only be removed from the ESD (electrostatic discharge) protective packaging just before installation and at the position at which the part is to be installed.
- Never touch the electric pins and plug contacts.
- The section of the main wire harness in the passenger compartment at the left is secured in reverse order.
- Secure the main wire harness and lines coming from it at the specified fastening points.
- Plug in electric plug connections until they engage securely.
Tighten fastening nut for fuse box at the left. → Tightening torque: 9.7 Nm (7.5 ftlb.)
Tighten fastening nuts securing bracket for control unit for front-end electronics. → Tightening torque: 3.5 Nm (2.5 ftlb.)
Tighten fastening nut for the ground straps. → Tightening torque: 9.7 Nm (7.5 ftlb.)