LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2016 >> 911 Turbo, 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.) >> 97 - Cables -- 911 CARRERA (991) >> WM 970909 Loosening And Securing Main Wire Harness In Front-End (Except CARRERA "Edition", CARRERA Cabriolet "Edition", CARRERA 4 "Edition", CARRERA 4 Cabriolet "Edition") >> Loosening Main Wire Harness In Engine Compartment >> Loosening Main Wire Harness In Left Wheel Housing

Loosening Main Wire Harness In Left Wheel Housing

  1. Release and unplug electric plug connection for airbag sensor. → 695119 REMOVING AND INSTALLING AIRBAG SENSOR
  2. Release and unplug electric plug connection for electric fan for radiator. → 190819 REMOVING AND INSTALLING ELECTRIC FAN
  3. Release and unplug electric plug connection for wire harness for front ABS. → 976519 REMOVING AND INSTALLING WIRE HARNESS FOR ABS 
  4. Release and unplug electric plug connection for level sensor. → 947819 REMOVING AND INSTALLING FRONT ANGLE SENSOR FOR HEADLIGHT BEAM ADJUSTMENT
  5. Disconnect electric plug connections for the steering gear.
    Fig 1: Disconnecting Connector For Steering Gear
    G09999500Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    1. 5.1. Release electric plug connection for steering gear -arrow a-  and unplug it -arrow A-  .
    2. 5.2. Turn electric plug connection 90° -arrow B-  and remove it from the holder.
    3. 5.3. Unclip B+ line connection from the bracket -arrow A-  .
      Fig 2: Disconnecting B+ Line Connection From Bracket
      G09999501Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    4. 5.4. Pull off the lock -arrow a-  and disconnect connector -arrow B-  .
  6. Release and unplug electric plug connection for hydraulic unit. → 453019 REMOVING AND INSTALLING HYDRAULIC UNIT
  7. Disconnect wire harness in the left wheel housing.
    1. 7.1. Make sure that all electric plug connections on the wire harness in the left wheel housing are released and unplugged.
    2. 7.2. Make sure that all brackets are unclipped and released.
    3. 7.3. Pull wire harness in the left wheel housing through the spring-strut mount into the plenum panel.