Installing Wiper Linkage

→ Switch off electric power to drive motor.

→ Make sure it does not switch on again.

→ Check that there is no electric charge.

1. Switch off ignition and remove remote control (hand-held transmitter) from the ignition lock.
2. Connect plug connection -arrow-  until it engages securely.
   Fig 1: Connecting Plug Connection

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Insert wiper linkage -A-  and position it -B-  .
   Fig 2: Fitting Wiper Linkage

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Fit fastening screws.
5. Tighten fastening screws in the specified sequence.
   Fig 3: Securing Wiper Linkage

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   • 5.1. Tighten fastening screw -1-  to the specified tightening torque → Tightening torque: 11 Nm (8 ft. lbs.)  .
   • 5.2. Tighten fastening screw -2-  to the specified tightening torque → Tightening torque: 11 Nm (8 ft. lbs.)  .
   • 5.3. Tighten fastening screw -3-  to the specified tightening torque → Tightening torque: 23 Nm (17 ft. lbs.)  .