Convertible Top, Hardtop
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Fastening nuts on convertible-top compartment lid | Tightening torque | 9.7 Nm (7.5 ftlb.) | |||
|
Removing convertible-top compartment lid |
|||||
| Fastening nut for convertible-top compartment lid | Targa | Tightening torque | 9.7 Nm (7.5 ftlb.) | ||
|
Removing convertible-top compartment lid |
|||||
| Fastening screw securing strut to convertible-top compartment lid bracket | Item 3 | Tightening torque | 9.7 Nm (7.5 ftlb.) | ||
|
Positioning glass dome |
|||||
| Fastening screws on trim panel for rear lid | Tightening torque | 2.2 Nm (1.5 ftlb.) | +/-0.2 Nm (+/- 0.1 ftlb.) | ||
|
Installation position of trim panel |
|||||
| Fastening nut securing rear window to convertible-top compartment lid | Tightening torque | 9.7 Nm (7.5 ftlb.) | |||
|
Removing rear window |
|||||
| Fastening screw for air deflector | Tightening torque | 3.4 Nm (2 ftlb) | |||
|
Removing air deflector |
|||||
| Fastening screws for upper part of lid lock | Tightening torque | 9.7 Nm (7.5 ftlb.) | |||
|
Removing upper part of lid lock |
|||||
| Fastening screws for front convertible top mount | Tightening torque | 36 Nm (27 ftlb.) | |||
|
Removing convertible top mount |
|||||
| Fastening screw for hydraulic cylinder | Tightening torque | 9.7 Nm (7.5 ftlb.) | |||
|
Pulling off safety clips |
|||||
| Fastening screw on convertible top support | Tightening torque | 23 Nm (17 ftlb.) | |||
|
Loosening convertible top support |
|||||
| Fastening screws for front lock | Tightening torque | 9.7 Nm (7.5 ftlb.) | |||
|
Removing lock |
|||||
| Fastening screw securing potentiometer to convertible top | Tightening torque | 2.7 Nm (2 ftlb.) | |||
|
Removing position sensor |
|||||
| Fastening nut for convertible-top compartment lid hinge | Tightening torque | 23 Nm (17 ftlb.) | |||
| Fastening screw for convertible-top compartment lid hinge | Tightening torque | 23 Nm (17 ftlb.) | |||
|
Loosening hinge |
|||||
| Fastening screw for convertible-top compartment lid hinge | Item 2 | Tightening torque | 23 Nm (17 ftlb.) | ||
|
Removing hinge |
|||||
| Fastening nut for convertible-top compartment lid hinge | Item 1 | Tightening torque | 23 Nm (17 ftlb.) | ||
|
Removing hinge |
|||||
| Gap dimension from side panel to convertible-top compartment lid (A) | Perfectly aligned | Gap dimension | 3.9 mm | +1 mm | -0.7 mm |
| Gap dimension from side panel/spoiler to convertible-top compartment lid (B) | Perfectly aligned | Gap dimension | 4.5 mm | +/-0.8 mm | |
|
Gap dimensions |
|||||