Removing Camshafts

Information 

• During removal, note the installation position and allocation of the camshafts and bearing covers on a sheet of paper in such a way that they cannot be mixed up. 
• Protect camshafts and bearing covers from dirt and place the components on a clean surface according to installation position. 

1. Slowly and uniformly loosen and then unscrew all M6 screws (according to cylinder bank) -1 and 6-3 and 5-  on the camshaft bearing covers -2. 4 and 5-2. 4 and 6-  ,

   The housings are marked E  for intake camshaft and A  for outlet camshaft. The housings are numbered consecutively by cylinder.

   The housings are seated very securely in the cylinder head because of a dowel sleeve -3-1-  , Jiggle free using a pliers if necessary.

   Place on a marked, clean surface.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Camshaft mount, cylinder bank 1 to 4

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Camshaft mount, cylinder bank 5 to 8

   Information 

   • The intake camshaft for cylinder bank 5 to 8 has a plastic loss preventer to prevent the high-pressure pump's drive coupling from falling off. 
   • If for some reason the plastic loss preventer was not installed, the drive coupling would fall off when the camshaft is removed. The high-pressure pump and its drive mechanism will still work even without the plastic loss preventer. 
2. Remove camshafts (according to cylinder bank) -1 and 2-3 and 6-  and place on a marked, clean surface. Turn the intake camshaft for cylinder bank 1 to 4 so that it can be lifted up and out of the drive coupling for the vacuum pump

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Camshafts, cylinder bank 1 to 4

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Camshafts, cylinder bank 5 to 8