LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Panamera 4S >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> 42 - Rear Wheel Suspension, Drive Shafts -- PANAMERA (970) >> WM 425219 Removing And Installing Rear Wheel Bearing Housing (Except PANAMERA Executive, PANAMERA GTS, PANAMERA Turbo S, PANAMERA 4 Executive, PANAMERA Platinum Ed., PANAMERA 4 Platinum Ed.) >> Removing Wheel Bearing Housing >> Replacing Wheel Bearing Housing

Replacing Wheel Bearing Housing

  1. Use puller set Nr.87-1 Pos.1  to press the drive shaft out of the wheel hub. → Pressing in drive shaft 
    Fig 1: Pressing In Drive Shaft
    G09807626Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Grease the splines with a little Optimoly TA aluminum paste and fit the drive shaft into the new wheel bearing housing. When doing this, press the inner joint together fully.
  3. Screw on the axle nut to prevent the shaft from slipping out.
  4. Tighten drive shaft.
    1. 4.1. Tighten the drive shaft to setting 1 "before installation" to Tightening torque 130 Nm (96 ftlb.)  . To do this, place the wheel carrier with the drive shaft and countering tool (shop-made) on the floor (do not damage the brake cover plate) and tighten the drive shaft. 2. second mechanic is required! → Tightening drive shaft 
    2. 4.2. The second tightening setting is applied when the wheel bearing housing is installed! Tightening torque 460 Nm (340 ftlb.) 
      Fig 2: Tightening Drive Shaft
      G09807627Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals