Installing Sunroof

Information 

• The punches have a diameter of 10 mm and 12.5 mm. 

1. Place the sunroof in installation position.
   1. 1.1. Guide the sunroof through the rear lid opening into the passenger compartment with the help of another person.
   2. 1.2. Fit the sunroof on the roof frame.
   3. 1.3. Screw in fastening screws and tighten so that the frame for the sunroof can still be moved slightly.
   4. 1.4. Move the sunroof until the locating bores are free.
   5. 1.5. Position the sunroof -1-  at the locating bores using the punches -2 and 3-  .
      Fig 1: Fitting Punches

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
2. Secure the sunroof.
   1. 2.1. Screw in front fastening screws -2a and 2b-  from the inside out → Tightening torque: 9.7 Nm (7.5 ftlb.)  .
      Fig 2: Identifying Securing Sunroof At Front

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   2. 2.2. Screw in side fastening screws -2c, 2d und 2e-  from front to rear → Tightening torque: 9.7 Nm (7.5 ftlb.)  .
      Fig 3: Securing Sunroof At Sides

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   3. 2.3. Remove the punches -2 and 3-  from the sunroof -1-  .
      Fig 4: Removing Punches

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
3. Connect plug connection for sunroof motor -1-  .
   Fig 5: Connecting Plug Connection

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.
4. Secure water drain hoses.
   1. 4.1. Connect front water drain hoses -2-  to the connection piece -1-  .
      Fig 6: Connecting Front Water Drain Hoses

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   2. 4.2. Connect side water drain hoses -2-  to the connection piece -1-  .
      Fig 7: Connecting Water Drain Hoses At Sides

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.
   3. 4.3. Check that the water drain hoses are seated securely.