LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 648 (47 Brakes- Brake Hydraulic System, Regulator, Booster -- (95B) MACAN) >> WM 473919 Removing And Installing Front Brake CALLIPER (Except MACAN Sport Edition) >> Removing And Installing Front Brake Calliper >> Removing Front Brake Calliper (17-Inch - Brake Calliper Colour: Black)

Removing Front Brake Calliper (17-Inch - Brake Calliper Colour: Black)

WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • To gain better access for removal of the brake calliper, turn the steering fully either to the right or left  .
    G11977641

    Overview of front brake calliper (17-inch) 

  1. Loosen holder -1-  for brake line, wear indicator and speed sensor on the wheel bearing housing.
    G11977642

    Holder on wheel bearing housing 

    Carefully pull contact for brake pad wear indicator out of the brake calliper and disconnect it at the holder.

    NOTE: Removal of brake calliper
    • Paint defects on brake calliper

      • → Proceed with care when setting back the brake pads.

      → Protect brake calliper from paint defects using a suitable cloth.

  2. Set the disc brake pads back slightly and uniformly using water pump pliers.
  3. Disconnect the brake line -arrow- at the brake calliper and collect brake fluid in a suitable container.
    G11977643

    Brake line on brake calliper 

  4. Close off brake line using a suitable stopper.
    NOTE:
    • Never use an impact bolter to loosen and tighten the brake calliper on the wheel bearing housing  .
  5. Loosen fastening screws -arrows-  and remove brake calliper from the wheel carrier.
    G11977644

    Mounting for brake calliper 

scientia non olet · About LEMON Manuals