LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 623 (40 Front Wheel Suspension, Drive Shafts -- (95B) MACAN) >> WM 405019 Removing And Installing Front Wheel Bearing Housing (Except MACAN Sport Edition) >> Removing And Installing Front Wheel Bearing Housing >> Removing front wheel bearing housing

Removing front wheel bearing housing

WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Unscrew fastening screws -arrows-  and remove brake cover plate -1-  .
    G11983817

    Mounting for brake cover plate 

  2. Press lower control arm off the wheel bearing housing.
    G11983818

    Pressing off lower control arm 

    1. 2.1. Screw off nut on joint pin for the control arm until it is flush with the thread of the joint pin (counter while loosening the nut).
    2. 2.2. Press off joint pin on the control arm using a ball-joint extractor press-out tool T40010  .
    3. 2.3. Screw off nut on joint pin for the axle joint.
      NOTE:

      The slots in the wheel bearing housing must not be widened using a chisel or similar tool!

  3. Unscrew fastening screw on the top of the wheel bearing housing -1-  and pull both trailing arms -2-  up and out.
    G11983819

    Mounting for trailing arm 

    NOTE:

    Drive shafts must not be left hanging from the joint stop! Hold the drive shaft or tie it up if necessary.

  4. Pull wheel bearing housing out of the drive shaft toothing and remove wheel bearing housing.
scientia non olet · About LEMON Manuals