LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 623 (40 Front Wheel Suspension, Drive Shafts -- (95B) MACAN) >> WM 401519 Removing And Installing Upper Trailing Arm (Except MACAN Sport Edition) >> Removing And Installing Upper Trailing Arm >> Removing upper trailing arm

Removing upper trailing arm

WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lift the wheel bearing housing.
    G11983785

    Mounting for support T10149 

    1. 1.1. Turn the wheel hub in such a way that a bore for a wheel bolt is at the top.
    2. 1.2. Support T10149  must be secured to the wheel hub with a wheel bolt -arrow- 
    3. 1.3. Support T10149  must now be fitted into the transmission jack WE 1082  .
    4. 1.4. Lift the wheel bearing housing.
  2. Separate threaded joint -1-  .
    NOTE:

    The slots in the wheel bearing housing must not be widened using a chisel or similar tool!

  3. Pull the two pins for the upper trailing arm -2-  out of the wheel bearing housing.
    NOTE:

    Do not lower the wheel bearing housing any lower than required.

  4. Unscrew nuts -3 and 6-  .
  5. Pull out screws -4 and 5-  .
  6. Remove upper trailing arm.
    G11983786

    Mounting for upper trailing arm 

scientia non olet · About LEMON Manuals