LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 619 (70 Linings, Insulation -- (95B) MACAN) >> WM 705719 Removing And Installing A-Pillar Trim Panel (All Models Except MACAN Edition) >> Installing A-pillar trim panel

Installing A-pillar trim panel

WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Check that the fixing clips are not bent or broken.

Check that all fixing clips are positioned fully and correctly.

Replace damaged or missing clips with new ones.

Installation is performed in reverse order. Pay particular attention to the following:

  1. Place rubber door seal over trim panel.
  2. Tighten fastening screw to the specified torque. Tightening torque 5.6 Nm (4 ftlb.) 
scientia non olet · About LEMON Manuals