LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 612 (42 Rear Wheel Suspension, Drive Shaft -- (95B) MACAN) >> WM 422119 Removing And Installing Rear Drive Shaft >> Removing and installing rear drive shaft >> Removing rear drive shaft

Removing rear drive shaft

WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Drive shafts must not be left hanging from the joint stop! Hold the drive shaft or tie it up if necessary.

  1. Tilt wheel bearing housing -1-  down slightly. A second mechanic must guide the drive shaft -2-  carefully out of the wheel bearing housing.
    G11985025

    Tilting wheel bearing housing 

  2. Lever out the drive shaft -1-  using a suitable tool (e.g using 2 mounting levers) and carefully remove it from the rear-axle transmission housing.
    IMPORTANT: Hold the drive shaft! In the event of unfavorable tolerances, the drive shaft might slip out.
    G11985026

    Drive shaft on transmission side 

scientia non olet · About LEMON Manuals