LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Rear Wheel Suspension, Axle Shaft - 911 CARRERA (996)) >> Removing and installing rear spring strut >> Installation

Removing and installing rear spring strut: Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Porsche 911, 2004 Porsche 911, 2003 Porsche 911, 2002 Porsche 911, and 2001 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install in reverse order. Before installing, give the parts a visual check. Replace fastening nuts.
  2. Do not grease screwed connections in Dacromet finish - aluminium color. Use correct tightening torques.
  3. Insert spring strut into vehicle. Before tightening the fastening nuts, adjust spring strut mount in accordance with the applied marking (position of the three fastening nuts). Tightening torque: 46 N.m (34 ftlb.)
  4. When new parts are installed that affect vehicle height, suspension alignment must be carried out.
scientia non olet · About LEMON Manuals