Installing Side Convertible Top Rooflining

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Check that the guide cables are routed correctly at the positions shown.

Do not cross over the front guide cables -A- and -B- .

Insert guide cable -A- into the clamps -1- .

Fig 1: Identifying Front Guide Cables

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Route the side guide cable -A- behind the control arm -1- .

Route the side guide cable -A- in front of the control arm -2- and the restraining strap -3- .

Fig 2: Locating Side Guide Cable

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Route control cable -A- at the guide eyelets as shown.

Fig 3: Locating Control Cable On Arms

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installation is performed in reverse order to removal.
Tightening torque 3.0 Nm (2 ftlb.)

Tightening torque 1.5 Nm (1 ftlb.)

Tightening torque 9.7 Nm (7.5 ftlb.)