DFI Fuel Lines
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Union nut on connecting line for cylinder 1-3 and 4-6 | M14 x 1.5 - coat thread and cone with OKS 1710 | Tightening torque | 20 Nm (15 ftlb.) | ||
| Union nut securing high-pressure pump line to connecting line | M14 x 1.5 - coat thread and cone with OKS 1710 | Tightening torque | 20 Nm (15 ftlb.) | ||
| Fuel collection pipes to cylinder head | External Torx screw, M6 x 30 | Tightening torque | 13 Nm (9.5 ftlb.) | ||
| Holder securing high-pressure line and low-pressure line to cylinder head | External Torx screw, M6 x 16 | Tightening torque | 13 Nm (9.5 ftlb.) | ||
| Holder securing connecting line to cylinder head | External Torx screw, M6 x 16 | Tightening torque | 13 Nm (9.5 ftlb.) | ||
| Holding clamp securing high-pressure line to sheetmetal bracket | External Torx screw, M6 x 12 | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| Holding clamp securing connecting line to sheetmetal bracket | External Torx screw, M6 x 12 | Tightening torque | 10 Nm (7.5 ftlb.) | ||
| High-pressure sensor to fuel collection pipe for cylinder 4-6 | M10 x 1 | Tightening torque | 22 Nm (16 ftlb.) | +/-2 Nm (+/-1.5 ftlb.) |