Removing Porsche Doppelkupplung (PDK)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Loosen cable duct -1- for battery positive cable (B+ line) on the Porsche Doppelkupplung (PDK).
1. 1.1. Unscrew three external Torx screws (M6 x 16) -2- . Lay cable duct aside.
  
  Fig 1: Identifying Cable Duct For B+ Line
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disconnect speed sender cable plug -1- and vacuum line -2- .
1. 2.1. Open retaining clip -arrow- and expose the cable.
  
  Fig 2: Locating Speed Sender Cable Plug And Vacuum Line
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Disconnect cooling water hoses -2- .
1. 3.1. Remove spring clamps -1- on the plug-in couplings and pull off hoses.
2. 3.2. Re-fit spring clamps.
3. 3.3. Check O-rings for damage and replace if necessary.
  
  Fig 3: Identifying Lines On Coolant Collection Unit
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Secure Porsche Doppelkupplung (PDK) -2- using restraining straps -1- .
1. 4.1. Get workshop crane ready.
2. 4.2. Fit restraining straps as shown in the illustration.
  
  Fig 4: Identifying Restraining Strap On Transmission
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  NOTE:
  Mechanical overload of components
  - Component will be damaged irreparably
  → Observe guidelines for assembly and disassembly
  
  Information
  - The splines of the transmission shaft must be removed completely from the flywheel before tipping off the transmission.
  - If this is not done, the diaphragm spring on the flywheel will be damaged and the flywheel must be replaced.
  Information
  
  Replace flange screws if necessary.
Remove Porsche Doppelkupplung (PDK).
1. 5.1. First unscrew screws -1 and 2- , then screws -3 to 6- .
2. 5.2. Pull PDK transmission away from the engine until the transmission shaft is separated completely from the flywheel splines.
3. 5.3. Replace screws if necessary (thread damage, corrosion)!
  
  Fig 5: Identifying Flange Bolts For Porsche Double-Clutch Transmission
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.