Information On Machining Grey Cast-Iron Brake Discs
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
Possible complaints
- Damage due to lack of use (rusting). This causes vibrations in the steering wheel, noises and brake pedal pulsation.
- Brake disc becomes distorted as a result of serious driving, e.g. on a racing circuit.
- Too much lateral runout when new brake discs are fitted on dirty or distorted wheel hubs.
Procedure
- Check brake disc for cracks, minimum thickness, lateral runout, thickness tolerance, flatness and surface roughness.
- If necessary, (depending on the actual brake disc thickness and the brake disc wear limit) machine the brake disc using one of the disc brake dressing machines approved by Porsche. For a list of recommended disc brake dressing machines .
- The brake disc must only be reworked symmetrically, i.e. evenly from both sides! Observe the operating instructions for the disc brake dressing machine!