Installing Engine Carrier - GT2 RS
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of objects or loads falling down
- Risk of squashing or crushing
→ Secure components to prevent them from falling down.
- Guide engine carrier into the threaded bolts on the engine mounting. Fit carrier and holder for rear silencer using four Torx screws (M10 x 70).
- Move the engine to installation position using a transmission jack or engine retainer plate and screw in two M12 collar nuts on the engine mounting.
- Tighten four M10 Torx screws. → Tightening torque: 65 Nm (48 ft. lb.)
- Tighten M12 collar nuts on the left and right engine mountings. → Tightening torque: 85 Nm (63 ft. lb.)