Technical Values
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Coolant drain plug | Replace sealing ring | Tightening torque | 10 Nm (7.5 ft. lb.) | +5 Nm (+3.5 ft. lb.) | |
| Crash support to joint | M8 | Tightening torque | 23 Nm (17 ft. lb.) | ||
| Collar nut on engine mounting | M12 | Tightening torque | 85 Nm (63 ft. lb.) | ||
| Transmission support to body | M10 | Tightening torque | 65 Nm (48 ft. lb.) | ||
| Crash support to joint | M8 | Tightening torque | 23 Nm (17 ft. lb.) | ||
| Clutch line | a/f 15 | Tightening torque | 30 Nm (22 ft. lb.) | ||
| Ground strap to body | M8 | Tightening torque | 23 Nm (17 ft. lb.) | ||
| Screw-type clamp on pressure hose for turbocharger | Tightening torque | 3 Nm (2 ft. lb.) | |||
| Drive shaft flange to manual transmission | M10 x 1 | Tightening torque | 90 Nm (67 ft. lb.) | ||
| Transmission bracket to body | M10 | Tightening torque | 65 Nm (48 ft. lb.) | ||
| Rear-axle carrier | M12 | Tightening torque | 110 Nm (81.5 ft. lb.) | ||
| Transverse strut to carrier side section | M10 | Tightening torque | 65 Nm (48 ft. lb.) | ||
| Diagonal brace to carrier side section | M10 | Tightening torque | 65 Nm (48 ft. lb.) | ||
| Diagonal brace to rear-axle carrier | M12 | Tightening torque | 110 Nm (81.5 ft. lb.) | ||
| Tailpipe cover to rear silencer | M8 | Tightening torque | 30 Nm (22 ft. lb.) | ||
| Wheel to wheel carrier | M14 | Tightening torque | 130 Nm (96 ft. lb.) |