Mounting Transmission

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Attach transmission to workshop crane.
Run in transmission.
NOTE:
Mechanical overload of components
- Component will be damaged irreparably
→ Observe guidelines for assembly and disassembly

Information

Always replace flange screws.

When you screw in and tighten the flange screws between the transmission and engine, the screws -1 and 2- must be screwed in and tightened last. If this is not done, the engine housing can be damaged irreparably.

Fig 1: Identifying Flange Screws Tightening Sequence
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screw in and tighten the four top fastening screws.

Location	Description	Type	Basic value	Tolerance 1	Tolerance 2
Transmission/engine connection		Tightening torque	85 Nm (63 ft. lb.)

Screw in and tighten the two bottom fastening screws.

Location	Description	Type	Basic value	Tolerance 1	Tolerance 2
Transmission/engine connection		Tightening torque	85 Nm (63 ft. lb.)

Fit cable duct.

Fig 2: Locating Cable Duct

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Location	Description	Type	Basic value	Tolerance 1	Tolerance 2
Cable duct	Fastening screws between cable duct and transmission	Tightening torque	10 Nm (7.5 ft. lb.)

Engage coolant lines in holder.

Fig 3: Locating Coolant Lines
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Adjust the shift and selector cables after installing the transmission. See → 341219 REMOVING AND INSTALLING SHIFT AND SELECTOR CABLES