LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (34 - Mechanical Gear-Shift System - Actuation, Housing -- CARRERA (997)) >> WM 343519 Removing And Installing Transmission (Except Turbo) >> Subsequent Work

Subsequent Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check transmission oil and top up if necessary. → WM 340135 CHECKING AND TOPPING UP TRANSMISSION OIL 
  2. Bleed the clutch hydraulic system. → WM 341219 REMOVING AND INSTALLING SHIFT AND SELECTOR CABLES (EXCEPT TURBO) 300107 BLEEDING THE CLUTCH SYSTEM
  3. Adjust the shift and selector cables. See → 341219 REMOVING AND INSTALLING SHIFT AND SELECTOR CABLES 
  4. Fit underbody panelling. → 519319 REMOVING AND INSTALLING CENTRE COVER - section on "Installing"→ 519419 REMOVING AND INSTALLING REAR COVER - section on "Installing"
  5. Lower the vehicle.
  6. Connect the battery. → WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY


  1. Install cardan shaft. → 390219 REMOVING AND INSTALLING CARDAN SHAFT - section on "Installing"
  2. Check transmission oil and top up if necessary. → 340135 CHECKING AND TOPPING UP TRANSMISSION OIL 
  3. Bleed the clutch hydraulic system. → 300107 BLEEDING THE CLUTCH SYSTEM
  4. Adjust the shift and selector cables. See → 341219 REMOVING AND INSTALLING SHIFT AND SELECTOR CABLES 
  5. Fit underbody panelling. → 519319 REMOVING AND INSTALLING CENTRE COVER - section on "Installing"→ 519419 REMOVING AND INSTALLING REAR COVER - section on "Installing"
  6. Lower the vehicle.
  7. Connect the battery. → 2706IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
scientia non olet · About LEMON Manuals