Assembly Work

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Porsche 911, 2012 Porsche 911, 2011 Porsche 911, 2010 Porsche 911, and 2009 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Information

Protect the drive shafts from mechanical damage.

Fit drive shafts on the transmission side. To do this, screw in the six Allen screws joining each drive shaft and transmission flange and tighten screws. Counter at the wheel to prevent it from turning as well.

Fig 1: Identifying Drive Shaft

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Location	Description	Type	Basic value	Tolerance 1	Tolerance 2
Drive shafts	Fastening screws between drive shaft and transmission flange	Tightening torque	81 Nm (60 ft. lb.)

Engage shift cable -1- (grey end piece) and selector cable -2- (blue end piece) in the support bracket on the transmission and press end pieces onto the ball joints.

Fig 2: Connecting Shift Cable
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fit electric cable (positive lead). Do this by fitting the holder on the transmission -arrows- and connecting cables in the B-Plus box -1- .

Fig 3: Routing Of B+ Line On Transmission

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Location	Description	Type	Basic value	Tolerance 1	Tolerance 2
Cable duct	Fastening screws between cable duct and transmission	Tightening torque	10 Nm (7.5 ft. lb.)
B+ cable	Fastening screws for B+ cable	Tightening torque	10 Nm (7.5 ft. lb.)

Connect electric connection to the reversing light switch.

Fig 4: Identifying Electric Plug For Reversing Light Switch
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fit the coolant lines and holders.

Fig 5: Locating Coolant Line On Transmission

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Location	Description	Type	Basic value	Tolerance 1	Tolerance 2
Holder for coolant lines	Fastening screws between holder and transmission	Tightening torque	10 Nm (7.5 ft. lb.)

Remove cross member.

Fig 6: Locating Cross Member

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Location	Description	Type	Basic value	Tolerance 1	Tolerance 2
Cross member	Fastening screws between cross member and carrier side section	Tightening torque	65 Nm (48 ft. lb.)