Preparing Bonding Surfaces
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
- The table below shows how to use cleaners, primers and activators when preparing the bonding surface.
| Preparing the body glass for installation | ||
|---|---|---|
| Old glass | New glass | |
| with preliminary coat (durable primer) | ||
| Cut back adhesive bead ↓ |
-cleaner- ↓ |
|
| Clean rim (ceramic layer with durable primer) ↓ |
||
| -activator- ↓ |
-primer- ↓ |
|
| Activate adhesive bead (only necessary after idle times > 24 h) ↓ |
Apply primer from the adhesive kit over the durable primer on the spare part ↓ |
|
| Applying adhesive | ||
| Install glass | ||
| Preparing the window flange for installation | ||
|---|---|---|
| Old flange (old paintwork) | New flange (new paintwork) | |
| Cut back adhesive bead ↓ |
-cleaner- ↓ |
|
| Clean flange surface ↓ |
||
| -activator- ↓ | -primer- ↓ |
|
| Activate adhesive bead (only necessary after idle times > 24 h) ↓ |
Prime flange surface ↓ |
|
| Apply adhesive | ||
| Install glass | ||