LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Macan Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (6X - Body-Equipment Outside - General -- PANAMERA (970)) >> WM 6X00IN Processing Of PORSCHE 2-Component Window Adhesive (Except PANAMERA Executive, PANAMERA 4S Sport Edition, PANAMERA 4 Executive) >> Combined Procedure (Handling Double Cartridge Press)

Combined Procedure (Handling Double Cartridge Press)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: → Observe the safety instructions of the individual adhesive set components.

Information 

  1. Prepare cartridge components A and B -H5, H6-  .
    1. 1.1. Pierce the membrane in the nozzle connection of components A and B (aluminum cartridge) -H5-  with a screwdriver and extend the opening. Remove flanged cover on end of cartridge.
      Fig 1: Piercing Membrane In Nozzle Connection Of Components
      G09810629Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Screw on mixing nozzle -H7-  .
    1. 2.1. Screw both cartridges onto the mixing nozzle.
  3. Place mixing cartridge into the double-cartridge gun
    1. 3.1. Move pressure piston back fully.
    2. 3.2. Insert double cartridge -H5, H6-  into the bonding gun -A-  .
  4. Press out adhesive
    1. 4.1. By activating the valve -arrow-  allow the pressure piston to move out slowly until both components of the bonding material emerge at the mixing pipe.
    2. 4.2. Wipe off emerging adhesive.
  5. Screw on processing nozzle -H8-  .
    1. 5.1. Screw processing nozzle -H8-  onto the mixing nozzle -H7-  .
  6. Align processing nozzle
    1. 6.1. Turn the processing nozzle on the mixing nozzle until the illustrated position is reached.

      Information 

      • In this position, the closed surfaces must be visible at the horizontal mixing nozzle from above and below and the mixing blade of the mixer insert from the sides. 
    2. 6.2.
  7. Mix adhesive components
    1. 7.1. By activating the valve -arrow-  allow the pressure piston to move out slowly until the adhesive is visible in the processing pipe.
      Fig 2: Activating Valve
      G09810630Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  8. Affix car window

    Information 

    • In order to ensure that the substance is completely mixed, apply a 30 mm long adhesive bead of fresh adhesive to a piece of cardboard before processing. 
    • The bonding material has an open time of  → working time: 15 min  , the bonding material must be applied and the window must be assembled within this time. 
    • Do not load bonded parts until hardening is complete! 
    • If the contents of the cartridge is not completely used up, the processing nozzle should not be removed until the adhesive has hardened on the cartridge. A new processing nozzle must be used for subsequent bonding work. 
    1. 8.1.
      Fig 3: Identifying Bonding Material Open Time
      G09810631Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals