Installing Rear Brake Calliper
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Old mounting parts fitted on the brake calliper
- Reduced braking effect
- Risk of damage to the brake calliper
→ Fit new pad retaining springs
The brake calliper is installed in reverse order.
Brake calliper to wheel bearing housing: Tightening torque 85 Nm (63 ftlb.)
Brake line on brake calliper: Tightening torque 14 Nm (10.5 ftlb.)
Holder to brake calliper: Tightening torque 10 Nm (7.5 ftlb.)
Information
- Never use an impact bolter to loosen and tighten the brake calliper on the wheel carrier.
- Carry out a visual inspection on the thread for the brake calliper and blow it out carefully if necessary using compressed air. Use goggles!
- Replace screws for securing the brake calliper.
- Check that all parts are in perfect condition (visual inspection) and replace them if necessary.
- Position disc brake pads by operating the brake several times.