Torque loss

Necessary after:

• Re-programming DME control unit
• Replacing DME control unit
• Re-programming PDK control unit

Necessary before:

• Re-calibrating PDK

How?

Engine idling

1. Preconditions:
   1. 1.1. Engine at operating temperature
2. Engine idling for 3 minutes without activating loads, press accelerator pedal once after approx. 1.5 minutes during this time
3. Engine idling for 3 minutes with air conditioning switched on, press accelerator pedal once after approx. 1.5 minutes during this time
4. Engine idling for 3 minutes with air conditioning switched on and transmission range engaged, press accelerator pedal once after approx. 1.5 minutes during this time
5. Switch off ignition (see also Information)