LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Macan Turbo >> Repair and Diagnosis >> Collision >> Body Panels >> 50 - Body Front - (95B) - MACAN >> WM 503955 Replacing Spring Strut Mount (All Models) >> Preparing Connection Areas Of The Body

Preparing Connection Areas Of The Body

  1. Align the sealing surface and connections of the body.
  2. De-burr connection points and prepare them for welding.

    Information 

    • Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
    • The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
    • Do not begin bonding work until all materials and tools necessary for later repair work are available. 
  3. Prepare the marked areas for welding and bonding. → 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE - section on "Preparing"
    Fig 1: Preparing Connection Areas Of Body (1 Of 2)
    G10030410Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    Fig 2: Preparing Connection Areas Of Body (2 Of 2)
    G10030411Courtesy of PORSCHE CARS NORTH AMERICA, INC.
    Orange Resistance spot-welding
    Green Resistance spot-welding + bonding
    Red Plug-welding/apply a full weld using inert gas without bonding
scientia non olet · About LEMON Manuals