Removing Lock Carrier
Information
- The number of fastening screws, fixing clips, plug connections, holders and trim panels can vary depending on equipment.
- The illustrations for removing and installing the drive mechanism are shown only on one equipment variant and may differ from the actual equipment variant.
- Some steps must be carried out automatically.
- Some of the repair illustrations show only one side of the vehicle.
- Disconnect battery ground strap.
- Remove engine cover.
- Remove rubber seal -4- on feed-through element for pressure pipe.
- Loosen hose clamp -2- securing throttle-housing cover to pressure pipe and remove cover from pressure pipe. → .
- Loosen clamp and disconnect hose -1- from pressure pipe.
- Loosen clamp and disconnect hose -6- from pressure line.
- Disconnect hose -5- from vacuum line for the ambient air valves.
- Release and disconnect electric plug connection -3- on the pressure sensor.
- Release and disconnect coolant vent line -2- on the bleeder valve -1- .
- Unclip and disconnect operating cable -3- for bonnet release from the bracket.
- Unscrew front fastening screws -4- on the mounting for the right headlight.
- Release and disconnect electric plug connections -1- for the front wire harness, unclip wire harness at the body and secure it to the lock carrier. .
- Unscrew side fastening screws -2- for the front retaining strips.
- Remove upper transverse strut for lock carrier at the body -1-
.
- 14.1. Unscrew fastening screws -3- at the top.
- 14.2. Unscrew fastening screws -2- at the sides.
- Unscrew top fastening screws -4- for the lock carrier.
- Swivel side sections of the air guides -4- inwards.
- Remove control unit for garage door opener -2- .
- Unscrew fastening screw for bracket for garage door opener control unit and remove bracket.
- Unscrew fastening screws -1- for supports at the lock carrier.
- Disconnect charge air hose -3- at the charge-air cooler.
- Disconnect hose from the recirculating air valve -2- on the intake manifold.
- Release and disconnect electric plug connection -4- at the coolant temperature sensor.
- Release and disconnect electric plug connections for the electric fans -5- and unclip the relevant wire harness at the lock carrier.
- Unclip wire harness -4- at the lock carrier and remove electric connector -5- on the lock carrier.
- Disconnect refrigerant lines -3- at the connection point to the condenser and close off openings using stoppers.
- Remove front air guides -6- for the charge-air cooler.
- Release and disconnect electric plug connections -2- for airbag sensors.
- Disconnect hose -1- for headlight cleaning system at the connection point -7- , unclip at the lock carrier and guide out.
- Remove upper coolant hose -1- at the radiator.
- Remove lower coolant hose -2- at the radiator.
- Release and disconnect connections for the transmission oil lines -3- and close off openings using stoppers.
- Secure lock carrier from falling down, unscrew fastening screws -1, 2- and remove lock carrier.