LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 800 (15 - Engine - Cylinder Head, Valve Control 4.8L Turbo -- 970 - PANAMERA (970)) >> WM, 153719 Removing And Installing Solenoid/Hydraulic Valve For Camshaft Adjuster >> Removing Solenoid/Hydraulic Valve For Camshaft Adjuster >> Removing Solenoid/Hydraulic Valve For Camshaft Controller

Removing Solenoid/Hydraulic Valve For Camshaft Controller

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2016 Porsche Panamera, 2015 Porsche Panamera, 2014 Porsche Panamera, 2013 Porsche Panamera, and 2012 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Unscrew and remove fastening screws for hydraulic valve -4-  .
  2. Carefully pull hydraulic valve up and out. To do this, use 9235 - relay puller  . Hold hydraulic valve only at the metal body.
    Fig 1: Camshaft Control Components Location
    G15198185Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Camshaft control

    1  Screw, M12 Tighten fully after setting valve timing. Always use a new screw
    2  Camshaft controller with integrated hexagon for countering
    3  Hydraulic valve for camshaft control
    4  Screw, M5x 12
  3. Visually inspect hydraulic valve strainer and clean with solvent naphtha if necessary. Replace hydraulic valve if heavily soiled
scientia non olet · About LEMON Manuals