Installing rear tie rod

WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Wheel bearing housing raised incorrectly

Risk of crushing
Risk of damage to components

→ Wear personal protective gear.

→ Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).

Information

All screws and threaded joints on the axle must be tightened in vehicle position. Vehicle position means: vehicle standing on its wheels, or the wheel suspension is raised with a universal
vehicle lift. Dimension -1- , from lower edge of wing to center of axle corresponds to vehicle position. The current height can be found in → 4495TW ADJUSTMENT VALUES FOR SUSPENSION ALIGNMENT . Always observe the following points!

Dimension 1 - center of wheel to lower edge of wing (rear axle shown)
Screws and nuts are Geomet-coated and must not be greased .

Installation is performed in reverse order.
Observe specified tightening torques:

Tie rod to wheel bearing housing: Initial tightening 90 Nm (67 ftlb.) Final tightening +90°

Tie rod to rear axle housing: Tightening torque 95 Nm (70 ftlb.)