Installing Exhaust System
WARNING: This page is about a different car, the 2018 Porsche Macan and 2017 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1. Tightening torque for nuts securing rear silencer holder to body: Tightening torque 20 Nm (15 ftlb.)
- 1.2. Tightening torque for screws securing rear silencer holder to rear body: Tightening torque 20 Nm (15 ftlb.)
- 1.3. Tightening torque for nuts on clamp: Tightening torque 33 Nm (24 ftlb.)
- 1.4. Align clamp.