LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 307 (21 - Exhaust Gas Turbocharging -- 911 CARRERA (991)) >> WM 214119 Removing And Installing Pressure Pipe (Turbo, Turbo S, Turbo CABRIO, Turbo S CABRIO) >> Removing Pressure Pipe

Removing Pressure Pipe

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect pressure pipe -1-  .
    1. 1.1. Loosen screw-type clamp -2-  on the throttle valve and pull off rubber sleeve.
    2. 1.2. Disconnect cable plug on boost pressure sensor -3-  .
    3. 1.3. Release and pull off vacuum lines -4-  .
    4. 1.4. Loosen clamps -arrows-  and pull off hose for acoustic simulator -6-  and vacuum hose -5-  .
      Fig 1: Locating Pressure Pipe Clamps (Upper Part)
      G09991339Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  2. Remove pressure pipe.
    1. 2.1. Loosen screw-type clamps -1-  and pull off pressure hoses -2-  .
    2. 2.2. Remove pressure pipe -3-  in an upward direction -arrow-  .
      Fig 2: Locating Pressure Pipe (Lower Part)
      G09991340Courtesy of PORSCHE CARS NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals