LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2015 >> Macan S >> Repair and Diagnosis >> External Pages >> Different car >> Section 288 (13 - Engine - CRANKGEAR, Pistons -- 911 CARRERA (991)) >> WM 137519 Removing And Installing Vibration Damper (Except CARRERA "Edition", CARRERA Cabriolet "Edition", CARRERA 4 "Edition", CARRERA 4 Cabriolet "Edition", Gt3, Gt3 RS) >> Removal >> Removing Vibration Damper

Removing Vibration Damper

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove heat shield on the engine carrier.
    1. 1.1. Unscrew three external Torx screws (M6 x 12) and remove heat shield.
  2. Position vibration damper -1-  for removal.
    1. 2.1. Turn the vibration damper clockwise using special tool turning device 9773 -3-  until one staking bore is flush with the bore in the crankcase.
    2. 2.2. Stake the vibration damper using one of the locating pins 9595/1 -4-  .
      3. Fig 1: Turning Vibration Damper
      G09990621Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  3. Unscrew fastening screw -10-  and remove dowel sleeve -11-  .
    Fig 2: Overview Of Engine Carrier
    G09990622Courtesy of PORSCHE CARS NORTH AMERICA, INC.
  4. Remove vibration damper.
    1. 4.1. Unscrew six external Torx screws (M8 x 1 x 25) -2-  and carefully guide the vibration damper out through the engine carrier.
    2. 4.2. Check the vibration damper and dowel pin for damage (e.g. cracks, deformation) and replace components if necessary.
    3. 4.3. Replace screws.
scientia non olet · About LEMON Manuals