Installing Air Cleaner Housing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2019 Porsche 911, 2018 Porsche 911, 2017 Porsche 911, 2016 Porsche 911, and 2015 Porsche 911. However, it is still accessible from the selected car via links, so may be relevant.

Position air cleaner housing in the engine compartment.
Fit rubber shroud -3- on the throttle housing.
1. 2.1. Tighten screw-type clamp.
2. 2.2. Connect connecting lines -1 and 2- and close spring band clamps.
  
  Fig 1: Identifying Throttle Housing Rubber Sleeve
  Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Fit and tighten fastening screws for the air cleaner housing.
Tool: Use 1/4-inch torque wrench -1-.

Fig 2: Tightening Air Cleaner Housing Fastening Screws (Right Side)
Courtesy of PORSCHE CARS NORTH AMERICA, INC.